Owner`s manual

20
NOTE: The Piano Reset procedure described under
Panel Controls also sends out “Reset All Controllers”
and “All Notes Off” MIDI messages, but on MIDI
Channel 1 only.
Default Key (F5)
The Default Key will reset any one of the following
EditModeparameterstoitsdefaultvalue:
• Program (F
#
5)
• BankLSB(A5)
• BankMSB(B5)
• DataCtrlAssign(C
#
6)
When the Default Key is applied to Program, Bank
MSB,orBankLSB,thoseparameterswillbereturned
to their default value of zero. When the Default
KeyisappliedtotheDataCtrlAssignparameter,
the[DATACONTROL]knobwillbereturnedtoits
defaultfunctionof“MetronomeTempo.”
To apply the Default Key, press the [FUNCTION]
buttontoenterEditMode.
Press the special function key for the Edit
Modeparameteryouwouldliketoreturnto
its default value.
This example will use the Program parameter.
Cancel Panic Data Contr Assign Bank MSB Bank LSB Program
Default
9 8 7 6 5 4 3 2 1 0
Enter
F
#
5
FUNCTION
Press the Default Key (F5).
Cancel Panic Data Contr Assign Bank MSB Bank LSB Program
Default
9 8 7 6 5 4 3 2 1 0
Enter
OnceyouhavepressedtheDefaultKey,theAllegro
willautomaticallybebackinPerformanceMode,
withtheselectedEditModeparameterreturnedtoits
default value.
NOTE: While in Edit Mode, if you happen to press
the Default Key without first choosing an Edit Mode
parameter, the Allegro will be returned to Performance
Mode, with no other changes.
To clear all battery backed memory and restore
all functions to their factory defaults, follow the
FactoryResetproceduredescribedinAppendixC:
Piano Resets (pg. 29).
Acompletelistingofdefaultvaluesforallfunctions
maybefoundinAppendixA:DefaultSettings
(pg. 26).
Sending MIDI Program Changes
TherearetwowaystosendMIDIProgramNumber
changes. You may either send a single specific
ProgramNumberorassignthe[DATACONTROL]
knobtosendMIDIProgramChanges.
TosendasinglespecicProgramNumber,[DATA
CONTROL] knob assignment remains unchanged:
• Press the [FUNCTION] button to enter
EditMode.
• Press the Program Key (F
#
5).
• Using the Numeric Data Entry keys, enter the
MIDIProgramNumberyouwanttosend.
• Press the Enter Key (C7) to send the
MIDIcommand.
9386 Williams Allegro manual_CS5.indd 20 12/3/10 4:02 PM