Technical information

Night Scan Chief
CHAPTER 2
INSTALLATION
Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform
installation, adjustments, and servicing. Only a properly trained and qualified certified electrician should
perform electric installations and service.
Safety Instruction -Trained Personnel Only! Only trained and qualified personnel should perform
installation, adjustments, and servicing. Only a properly trained and qualified certified electrician should
perform electric installations and service.
Lifting Hazard! Manually lifting over 55 lb (25kg) is prohibited. In the UK, all lifting equipment must be
thoroughly examined annually by a competent person according to the Lifting Operations and Lift Equipment
Regulations 1998. Equivalent regulations exist in other EU states.
2.1 INTRODUCTION
The Chief has been designed to provide for ease of installation. This section of the manual provides the
procedures that must be followed to insure a successful installation. Be sure to read and understand the
entire installation procedure before you begin.
2.2 TOOLS AND MATERIALS REQUIRED FOR INSTALLATION
Table 2-1 provides a list of tools and materials required to install and test the Night Scan Chief.
Wrenches Crimping tool or Solder set
Screwdrivers Wire cutter/stripper
½ inch or M12 Mounting Hardware (6 each) Multimeter (to verify power is turned OFF)
Torque wrench Clean Shop Rags
Drill
Hoist (minimum 250 lb capacity)
Table 2-1. Tools and Materials Required for Installation
Revision 1 2-1