Tus neeg siv phau ntawv

Table Of Contents

Product: Wiliot single-band Bridge

Model No: MNSB1

General description

The Wiliot single-band Bridge enables a reliable wireless power network for Wiliot IoT tags.

The bridge scans for Wiliot’s tags and echo their data to the nearest Gateway device.

It is a low cost & small form-factor device and can be easily installed on both ceilings and walls using

the supplied screws or adhesive sticker.

Box content:

1. MNSB1 Bridge

2. Adhesive sticker

3. USBc cable

4. Screws

Deployment Guidelines

1. Mount the MNSB1 on a wall or ceiling using the supplied screws or the adhesive sticker -

Position the bridges to broadcast towards the area where the Wiliot IoT tags expected to be.

2. Connect the USBc cable to the MNSB1 bridge and a power supply / wall outlet.

3. Once connected to power, the Green LED turns on solid for 30 seconds indicating that the

bridge is running and BLE.

PAGE 1
Product: Wiliot single-band Bridge Model No: MNSB1 General description The Wiliot single-band Bridge enables a reliable wireless power network for Wiliot IoT tags. The bridge scans for Wiliot’s tags and echo their data to the nearest Gateway device. It is a low cost & small form-factor device and can be easily installed on both ceilings and walls using the supplied screws or adhesive sticker. Box content: 1. 2. 3. 4. MNSB1 Bridge Adhesive sticker USBc cable Screws Deployment Guidelines 1.
PAGE 2
4. After about 30s, the bridge starts RF power transmission - the green light flickers on and off, and the red-light flashes. FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
IC Caution: - English: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: This device may not cause interference. This device must accept any interference, including interference that may cause undesired operation of the device.