Datasheet

60
|
CHAPTER 2 Files and File Types
Installing Enablers
Some object enablers have dependencies on other enablers; therefore, you must install them in a
specific order. This is the case with the older enablers, especially the AutoCAD MEP 2009 enabler,
which was dependent on the AutoCAD Architecture 2009 enabler. As a result, you must install the
AutoCAD MEP enabler after the AutoCAD Architecture enabler. The 2010 versions and newer of the
MEP/Architecture enablers have been combined so this issue has been addressed.
Once the object enabler is installed, you need to configure Navisworks to recognize this file.
These next steps will guide you through the process of configuring for the DWG file:
1. Open Navisworks, but don’t open any files just yet.
2. Select the green application icon in the upper-left corner; click the Options button toward
the bottom.
3. In the Options Editor, choose File Readers from the hierarchy and expand as shown in
Figure 2.31.
Figure 2.31
Options Editor
006788c02.indd 60 6/23/11 1:47:43 AM