Datasheet

Chapter 1 • The Revit World
22
FIGURE 1.30 Just because you started the command from the view
window does not mean you do not have to look at your options.
8. With the wheel button on your mouse, zoom into the upper corner
of the building and select the top endpoint of the wall, as shown in
Figure 1.31. The point you are picking is the corner of the heavy lines.
The topmost, thinner line represents a concrete belt course below. If
you are having trouble picking the correct point, don’t be afraid to
zoom into the area by scrolling the mouse wheel.
FIGURE 1.31 Select the top corner of the wall to start your new radial wall.
9. Select the opposite, outside corner of the bottom wall. Again, to be
more accurate, you will probably have to zoom into each point as you
are making your picks.
10. Move your cursor to the right until you see the curved wall pause.
You will also see an alignment line and a tangent snap icon appear as
610114c01.indd 22610114c01.indd 22 12/7/10 3:29:38 PM12/7/10 3:29:38 PM