Datasheet

The Revit Architecture Interface
15
FIGURE 1.19 The procedure for drawing a wall in Revit Architecture
4. With the Wall command still running, move your cursor straight up
from the endpoint of your 100
′-long wall. Look at Figure 1.20.
5. Type 80 and hit Enter. You now have two walls.
6. Move your cursor to the right until you “run into” another blue
alignment line. Notice that your temporary dimension says 100
′–0″.
Revit understands symmetry. After you see this alignment line, and
the temporary dimension says 100
′–0″, pick this point.
7. Move your cursor straight down and type 16, and hit Enter.
8. Move your cursor to the right and type 16, and hit Enter.
9. Press the Esc key.
Do your walls look like Figure 1.21? If not, try it again. You need to be com-
fortable with this procedure (as much as possible).
610114c01.indd 15610114c01.indd 15 12/7/10 3:29:38 PM12/7/10 3:29:38 PM