Datasheet

The Revit Architecture Interface
21
FIGURE 1.30: Just because you started the command from the view
window does not mean you do not have to look at your options.
7. Again with the Options? Yes. Make sure your Location Line: is set to
Finish Face Exterior.
8. With your wheel button on your mouse, zoom into the upper corner
of the building and select the top endpoint of the wall, as shown in
Figure 1.31. The point you are picking is the corner of the heavy
lines. The topmost, thinner line actually represents a concrete belt
course below.
FIGURE 1.31: Select the top corner of the wall to start your new
radial wall.
9. Select the opposite, outside corner of the bottom wall.
10. Move your cursor to the right until you see the curved wall pause.
You will also see an alignment line and a tangent snap icon appear as
well. Revit understands that perhaps you want an arc tangent upon
the two lines you have already placed in your model.
11. Once you see this, pick the third point. Your walls should look like
Figure 1.32.
47222c01.indd 21 8/12/10 11:16:18 AM