Datasheet

The Revit Architecture Interface
19
line appear, as illustrated in Figure 1.27. Once the alignment line
appears, you can pick another point along the path. Once you pick
the second point, the walls are mirrored and joined with the south
wall. Again, refer to Figure 1.27.
FIGURE 1.27: Mirroring these walls will involve first, picking the midpoint
of the vertical wall, then second, picking a horizontal point along the plane.
Now that you have some experience mirroring items, it is time to start adding
components to your model by utilizing the items that have been placed previously.
If you are not getting it, retry these first few procedures. Rome was not built in a
day. (Well, perhaps if they had Revit, it would have sped things up!) You want
your first few walls to look like Figure 1.28.
FIGURE 1.28: Your building should look like this illustration.
47222c01.indd 19 8/12/10 11:16:18 AM