Datasheet

Chapter 1 • The Revit World
18
FIGURE 1.24: The Ribbon adds the appropriate commands.
FIGURE 1.25: There are options you will have to choose for every
command in Revit.
4. Make sure the Copy checkbox is selected (see Figure 1.25).
5. Hover your cursor over the inside face of the 80'–0"-long vertical wall
until you get to the midpoint. Revit will display a triangular icon, indi-
cating that you have found the midpoint of the wall. See Figure 1.26.
FIGURE 1.26: Revit has snaps similar to most CAD applications. In Revit,
you will only get snaps if you choose the draw icon from the Options bar during a
command.
6. Once the triangular midpoint snap appears, pick this point. Once
you pick the point where the triangle appears, you can move your
cursor directly to the right of the wall. You will see an alignment
47222c01.indd 18 8/12/10 11:16:17 AM