Datasheet

Waguespack c01.tex V2 - 08/30/2008 1:44pm Page 2
2 CHAPTER 1 INVENTOR DESIGN PHILOSOPHY
Figure 1.1
Left: the 2D Sketch
panel; right: the Part
Features panel
When working with assemblies, the tool panel changes to the Assembly panel (as shown on
the left of Figure 1.2). When you create a 2D drawing of parts or assemblies, you see the Drawing
Views panel, as shown on the right of Figure 1.2.
Figure 1.2
Left: the Assembly
panel; right: the
Drawing Views panel
As you can see, the icons on the tool panels change with every environment. There is no need
to display every possible command in the user interface.