Installation Manual

Torque to 10 ft-lb /
13.5 N-m
using general
purpose anti-seize
compound on
threads
WEEB Bonding Jumper
Torque to 10 ft-lb /
13.5 N-m
using general
purpose anti-seize
compound on
threads
WEEB Bonding Jumper
Drill 17/64" clearance hole to
install WEEB Bonding Jumper
WEEB Bonding Jumper
The WEEB Bonding Jumper can be use to electrically connect any two pieces
of anodized aluminum, galvanized steel, steel and other electrically
conductive metal.
Important note:
Before tightening WEEB Bonding Jumper mounting screw, ensure 1.
that the WEEB teeth face towards the aluminum surface and not the
WEEB Bonding Jumper. The WEEB-6.7 washer should lie completely
between the ends of the WEEB Bonding Jumper and the grounding
surface.
WEEB washers are intended for SINGLE USE ONLY . Functionality 2.
will not be guaranteed if reused.
Tighten mounting screw to 10ft-lb/13.5N-m to ensure that the WEEB- 3.
teeth fully embed into the mounting surface. Use general purpose
anti-seize compound on threads.
Wiley Electronics LLC. 2006-2009



All Rights Reserved
OK
OK