Installation Manual

Module Mounting Frame

WEEBL-6.7 assembly

Important note:

Before tightening WEEBLug mounting screw, ensure that the WEEB

teeth face towards the aluminum surface and not the WEEBLug. The

WEEB-6.7 washer should lie completely between the WEEBLug and

the grounding surface.

WEEB washers are intended for

SINGLE USE ONLY

. Functionality

will not be guaranteed if reused.

Tighten mounting screw to 10ft-lb/13.5N-m to ensure that the WEEB-

teeth fully embed into the mounting surface. Use general purpose

anti-seize compound on threads.

Solar Module Frame

Solar Module

Mounting Hole

WEEBL-6.7 assembly

Connect Solar Module Frame to Ground Conductor

Connect Mounting Frame to Ground Conductor

WEEBL-6.7 assembly

The following are a few universal ways to use the WEEBL-6.7 assembly

with an equipment ground conductor. No removal of the anodized surface

is required.

Wiley Electronics LLC. 2006-2009





