Instructions / Assembly

ASSEMBLY INSTRUCTIONS
classic glider
330-893-4212 • www.wildridge.com
LCC209
© 2014
Step 1
Position the backrest (A) and the seat (B) as shown. Fasten the
backrest to the three seat supports with (6) 1/4” x 2” bolts and
(6) 1/4” ange nuts, two per support.
Step 2
Position the right arm assembly (C) as shown. Fasten the arm to
the backrest using (1) 1/4” x 4” bolt and 1/4” ange nut, then fasten
it to the seat using 1/4”x 3 1/2” bolt and (1) 1/4” ange. Repeat
with the left arm assembly (D) on the other side.
Required Tools:
- Mallet/Non Marring
Hammer
(Do not use Metal Headed
Hammer)
- Cordless Drill
- #2 Square Drive bit
- 9/16” and 7/16” Wrench or
Socket
Hardware:
- (6) 1/4” x 2” Bolts
- (2) 1/4” x 3 1/2” Bolts
- (2) 1/4” x 4” Bolts
- (10) 1/4” Flange Nuts
- (8) 3/8” x 2 1/2” Bolts
- (16) 3/8” Washers
- (8) 3/8” Locknuts
- (4) Glider Hangers
- (8) 3” Screws
Parts:
A = (1) Backrest
B = (1) Seat
C = (1) Right Arm Assembly
D = (1) Left Arm Assembly
E = (2) Glider Bases
F = (2) Supports
D
A
B
C
E
E
F
F
A B
• (1) 1/4” X 4”
Bolt
• (1) 1/4”
Flange Nut
• (1) 1/4”
X 3 1/2”
Bolt
• (1) 1/4”
Flange
Nut
C