Instructions / Assembly

ASSEMBLY INSTRUCTIONS
classic glider
330-893-4212 • www.wildridge.com
LCC209
© 2014
Step 3
Stand the glider bases (E) upright, as shown, making sure the
countersink holes are facing outward and the ends of the base
pieces that are at an angle both go towards the same end. Position
the supports (F) in between the two glider bases, as shown. Fasten
the supports to the glider base with (8) 3” screws, two per end on
both sides of the base.
Step 5
Place the seat assembly over the base assembly, turning the
base so the part that has an angle goes towards the back of the
glider. Slide (1) 3/8” washer onto (1) 3/8”x 2 1/2” bolt and push it
through one of the holes from the outside to the inside on the arm
assembly and through the glider bracket, add (1) 3/8”washer and
(1) 3/8” locknut, do the same for the second hole. Repeat with the
other arm assembly on the other side of the glider.
E
F
Step 4
Slide (1) 3/8” washer onto (1) 3/8” x 2 1/2” bolt and tap it through
one of the holes on the top of the glider base from the inside to
the outside, and add (1) 3/8” washer, then place a glider bracket
with the curve facing away from the base onto the bolt, and add
(1) 3/8” locknut. (Note: The glider bracket will be on the outside
of the base so you can attach it to the arm assembly in Step 5).
Repeat with remaining 3 glider brackets on remaining 3 holes.
E
F
The Glider Bracket Needs To
Angle Away From The Base
Or It Will Not Glide Correctly
Step 6
Your glider is now complete.
Thank you for purchasing from Wildridge.
Angled
End
Pieces
(4) 3” Screws, 2 Per Side
(Repeat On Other End)
The Angled Part
Of The Base Goes
Towards The Back
• (1) 3/8”X 2 1/2” Bolt
• (2) 3/8” Washer
• (1) 3/8” Locknut