Instructions / Assembly

ASSEMBLY INSTRUCTIONS
classic
adirondack glider
330-893-4212 • www.wildridge.com
LCC208
© 2020
Required Tools:
- Mallet/Non Marring Hammer
(Do not use Metal Headed Hammer)
- Cordless Drill
- #2 Square Drive Bit
- 9/16" And 7/16" Wrench Or
Socket
Hardware:
- (8) 1/4" X 2 3/4" Bolts
- (2) 1/4" X 2" Bolts
- (10) 1/4" Flange Nuts
- (4) 3/8" X 2 1/4" Machine Bolts
- (4) 3/8" X 2 1/2" Machine Bolts
- (8) 3/8" Lock Nuts
- (16) 3/8" Washers
- (8) 3" Screws
- (6) 2 1/2" Screws
- (4) 2" Screws
- (4) Glider Brackets
Parts:
A = Back
B = Seat
C = Left Arm Assembly
D = Right Arm Assembly
E = Glider Base
F = Angle Iron
G = Base Support Brackets
Step 1
Position the back (A) onto the seat (B) as shown.
Keeping the side and back ush, fasten with (3)
2 1/2" screws through the pre-drilled holes.
Step 2
On the back side of the swing, place the angle iron (F) onto the frame where the
back and the seat meet, as shown. Fasten the angle iron to the frame with (3) 2 1/2"
screws though the pre-drilled holes in the angle iron.
A
B
C
E
G
F
D
A
B
F
E