Instructions / Assembly

ASSEMBLY INSTRUCTIONS
ClassiC mission glider
330-893-4212 • www.wildridge.com
LCC207
© 2018
Step 1
Position seat (B) and
back (A) and fasten
outside supports with
(4) 2" bolts & ange
nuts on both sides as
shown above.
Use the 1/2" x 1 1/2"
x 5" connector block
(F) provided to fasten
center seat support to
the back using
(4)1 1/4" screws, as
shown on right.
Required Tools:
- Mallet/Non Marring Hammer
(Do not use Metal Headed Hammer)
- Cordless Drill
- #2 Square Drive bit
- 9/16” and 7/16” Wrench or Socket
Hardware:
- (4) 1/4” x 2” Bolts
- (2) 1/4” x 4” Bolts
- (2) 1/4” x 3 1/2” Bolts
- (8) 1/4” Flange Nuts
- (4) Glider Hangers
- (8) 3/8” x 2 1/2” Bolts
- (16) 3/8” Washers
- (8) 3/8” Locknuts
- (4) 1 1/4” Screws
- (8) 3” Screws
Parts:
A = (1) Back
B = (1) Seat
C = (2) Arm-Leg Assembly
D = (2) Glider Base Assembly
E = (2) Base Support
F = (1) Connector Block
Step 2
Position the right arm-leg assembly (C) in position as shown
and attach it to the seat/back assembly using a 4" bolt & a
ange nut in the back and a 3 1/2" bolt & ange nut in the
front. Repeat with the left arm-leg assembly.
A
B
CC
D
D
E
F
A
C
Fasten Outside
Supports On
Both Sides
B
B
F
A
Connector
Block (F)
Will Go
Here
4” Bolt &
Flange Nut
3 1/2”
Bolt &
Flange
Nut