Instructions / Assembly

ASSEMBLY INSTRUCTIONS
HERITAGE SINGLE GLIDER
330-893-4212 • www.wildridge.com
LCC-106
© 2019
Required Tools:
-Mallet/Non Marring Hammer
-Cordless Drill
-1/2" and 9/16" Wrench or Socket
-#2 square drive bit
Hardware:
-(4) 5/16" x 5" Bolts
-(4) 5/16 x 3 1/2" Bolts
-(2) 1/4" x 4" Carriage Bolts
-(2) 1/4" Flange Nuts
-(8) 5/16 Flange Nuts
-(8) 3/8" x 2 1/2" Bolts
-(8) 3/8" Locknuts
-(16) 3/8" Washers
-(4) Glider Brackets
-(12) 3" Screws
Parts:
A = (1) Backrest
B = (1) Seat
C = (1) Right Arm/Leg Assembly
D = (1) Left Arm/Leg Assembly
E = (2) Base Pieces
F = (2) Cross Members
D
A
B
C
E
E
F
F
Step 1
On a level surface, place the backrest (A) and the seat (B) on its side, butting them up against each other. Lay the right arm/leg assembly
(C) onto the backrest and seat and fasten them together. For the front leg use (2) 5/16” x 3 1/2” bolts and (2) 5/16” ange nuts. For the back
leg use (2) 5/16” x 5” bolts & (2) 5/16” ange nuts, and for the armrest use (1)1/4” x 4” bolt & (1) 1/4” ange nut. DO NOT TIGHTEN NUTS
AT THIS TIME. Repeat with the left arm/leg assembly (D) on the other side. Tighten nuts.
(1) 1/4” x 4” Bolt &
(1) 1/4” Flange Nut
(2) 5/16” x 5” Bolts &
(2) 5/16” Flange Nuts
(2) 5/16” x
3 1/2” Bolt
& (2) 5/16”
Flange Nuts
A
B
C