Assembly Instructions

OUTDOOR SHOWER
Assembly Instructions
Step 6
Remove the bolt & washer from the L-shaped pipe ( 4 ) holder, position the holder to
align with the threaded hole of upper pole (F), then secure with washer, screw into
the holder from the back of upper pole (F), tighten with a Phillips screwdriver. Insert
the bottom end of the L-shaped pipe into the faucet ( 1 ), ensure that the rubber
washer is in place before tightened.
Attach the shower head ( 3 ) onto the top end of the L-shaped pipe. In the event that
there is water leakage on any connection joint, please reinforce with waterproof
adhesive tape on the thread of the connection joint.
Assembly is completed.
Page 6 of 6