TWIN / TWIN BUNKBED ASSEMBLY INSTRUCTIONS PAGE 1 OF 8
ASSEMBLY INSTRUCTIONS ASSEMBLY TIPS: 1. Remove hardware from box and sort by size 2. Please check to see that all hardware and parts are present prior to start of assembly. 3. Please follow attached instruction in the same sequence as numbered to assure fast & easy assembly. ! Warning! 1. Don't attempt to repair or modify parts that are broken or defective. Please contact the store immediately. 2. This product is for home use only and not intended for commercial establishments.
ASSEMBLY INSTRUCTIONS STEP 1 1.1) Insert wood dowel to lower bed end. 1.2) Align and fasten lower bed rail and lower front bed rail to lower bed end using nut and long bolt. Tighten with Allen wrench. STEP 2 Align and fasten roll slat to bed rails using flat head screw and tighten with screw driver (not included).
ASSEMBLY INSTRUCTIONS STEP 3 3.1) Insert wood dowel to left and right upper bed end. 3.2) Align and fasten upper bed rail and upper front bed rail to left and right upper bed end using nut and long bolt. DO NOT TIGHTEN AT THIS STEP. 3.3) Align and fasten long guardrail to left and right upper bed end using nut and long bolt. THEN TIGHTEN ALL THE BOLTS AT STEP 3.2 & 3.3 WITH ALLEN WRENCH. STEP 4 4.1) Insert wood dowel to the end of short guardrail. 4.
ASSEMBLY INSTRUCTIONS STEP 5 Align and fasten ladder step to left and right ladder stile using Allen cap screw and tighten with Allen wrench.
ASSEMBLY INSTRUCTIONS STEP 6 Insert metal rod to the top of lower bed end. Align and place the upper bed end onto the lower bed end. STEP 7 Align and fasten ladder stile to the lower and upper front bed rail using short bolt and tighten with Allen wrench.
SAFETY WARNING 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Follow the information on the warning attached to the upper bunk end structure and on the carton. Do not remove this label. Always use the recommended size mattress or mattress support or both to help prevent the likelihood of entrapment or falls. Surface of mattress must be at least five inches (127mm) below the upper edge of guardrails. Do not allow children less than six years of age to use the upper bunk. Prohibit more than one person on upper bunk.
1. When using beds as bunk beds, the ladder MUST be securely attached to the upper bunk rail at all times. 2. When using the beds as two (2) separate floor-standing beds, the ladder MUST be stored in a separate location where children cannot use the ladder in any manner. 3. DO NOT use, nor permit children to use, the ladder in any manner whatsoever, other than to access the top unit when used as bunk beds, and only if the ladder is securely attached to the top bunk rail, as set forth in the instructions. 4.
