Assembly Instructions

PARTS IDENTIFICATION
This tip restraint must be attached to a wall
stud using long screw enclosed.
ANTI - TIPPING KIT
A. CHEST 1 SET
HARDWARE IDENTIFICATION
1. 1 PC.SHORT SCREW
2. 1 PC.LONG SCREW
3. 1 PC.CABLE TIE
4. 2 PCS.L BRACKET
STEP 1
Attach a bracket securely to the back top rail of the
chest using short screw provided, through the
smaller hole.
STEP 2
Locate the other bracket on the wall over a wall
stud and two inches below the mounting bracket
secured to the back of chest. Attached to the wall
stud using the long screw provided, through the
smaller hole.
1
4
A
2
4WALL
WALL
4
3
4
STEP 3
Place the chest into position so both mounting brackets are vertically in line. Lace the end of the
restraint strap through the larger hole in each mounting bracket. Bring both ends together and slide
the flat end through the locking end and draw it through until all slack is removed. Confirm that the
strap is securely laced and locked.
PAGE 3 OF 3