User's Manual

Chapter 4: Maintenance and Troubleshooting

Parts Replacement and Adjustments

(12/00) 4-3

Parts Replacement and

Adjustments

WARNING

DISCONNECT ALL POWER TO THIS UNIT BEFORE INSTALLING,

SERVICING, CLEANING, OR REMOVING THE FUSE. FAILURE TO DO SO

COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.

CAUTION

BEFORE CONNECTING OR DISCONNECTING ANY INTERNAL ELECTRONIC COMPONENTS OR

INTERCONNECTING WIRING BETWEEN ELECTRONIC EQUIPMENT, ALWAYS REMOVE POWER

AND WAIT AT LEAST THIRTY (30) SECONDS. FAILURE TO OBSERVE THESE PRECAUTIONS

COULD RESULT IN DAMAGE TO OR DESTRUCTION OF THE EQUIPMENT, OR BODILY HARM.

Battery Replacement

The battery symbol at the lower left of the display is used to indicate low battery power.

The cursor above the battery symbol will illuminate when there is approximately 15

minutes of operation remaining.

When the cursor is “on” above the battery symbol, change the batteries as soon as

possible. To change the batteries:

1. Open the battery door on the rear of the WILDCAT terminal.

2. Remove the six batteries.

CAUTION

THE WILDCAT SCALE CANNOT RECHARGE BATTERIES. IF RECHARGEABLE

BATTERIES ARE USED, THEY MUST BE RECHARGED WITH A COMMERCIALLY

AVAILABLE RECHARGER THEN REINSTALLED INTO THE TERMINAL.

3. Insert six new or recharged “D” size batteries as illustrated on the battery housing.

+ -

Figure 4-1

Top

ure 4-2 - Shown With Rear Batter

Panel Removed