Manualshelf

User's Manual

ManualsBrandsWildcat Territory ManualsPostal EquipmentWildcat Territory Scale E15609900A
21222324252627282930
Chapter 4: Maintenance and Troubleshooting
Cleaning
(12/00) 4-1
4 Maintenance and Troubleshooting
Cleaning
WARNING
DISCONNECT ALL POWER TO THIS UNIT BEFORE INSTALLING,
SERVICING, CLEANING, OR REMOVING THE FUSE. FAILURE TO DO SO
COULD RESULT IN BODILY HARM AND/OR PROPERTY DAMAGE.
Periodically clean the keyboard and covers with a soft clean cloth that has been
dampened with a mild window type cleaner or detergent. DO NOT USE ANY TYPE OF
INDUSTRIAL SOLVENT OR CHEMICALS. DO NOT SPRAY CLEANER DIRECTLY ONTO THE
UNIT. DO NOT HOSE DOWN.
Troubleshooting
If operational difficulties are encountered, first obtain as much information as
possible regarding the problem. Failures and malfunctions often may be traced to
simple causes such as loose connections, low battery power, or improper setup.
Additional troubleshooting is best performed by substitution. A PCB or load cell believed
to be defective may be checked by replacing the suspect part with known good part and
then observing whether the problem is corrected.
Error Codes
The following table lists the WILDCAT scale’s error messages.
Error Message Description Probable Action
E1
ROM error Check Power Supply Voltages. Replace Controller PCB.
E2
Internal RAM error Check Power Supply Voltages. Replace Controller PCB.
E7
EEPROM data incorrect. Check Power Supply Voltages. Replace Controller Logic PCB.
E30
Scale in motion during calibration Press PRINT to return to [E SCAL] or [ ADD LD].
E32
Insufficient calibration test weight
or insufficient signal from load cell
Press PRINT, then add additional test weight. Recalibrate using more
test weight.
E34
Calibration Test Weight too large Press PRINT
.
Use test weight less than 100% of scale capacity.
E E E
Scale not zeroed at power up Auto Zero on power-up (F2.9) is enabled and the weight is greater
than zero. Zero the scale or remove the weight until zero is captured.
Re-calibrate the scale.
-E E E
Scale not zeroed at power up.
Auto Zero on power-up (F2.9) is enabled and the weight is on the
platform. Add weight until zero is captured. (Put platform on). Re-
calibrate the scale.