User's Manual

Chapter 3: Programming and Calibration
Entering and Configuring Program Blocks
(12/00) 3-3
Entering and Configuring
Program Blocks
Once the [F1] prompt is displayed, use the PRINT key to enter the block. Use the
FUNCTION key to skip to the next block. Use the ZERO key to go to the previous block.
Once PRINT is pressed, the configuration advances to the first parameter in the F1
program block. The display shows the sub-block number and the current value setting.
Press PRINT to accept the value and advance to the next sub-block or press the
FUNCTION key to toggle through the choices until the desired selection is displayed.
After the desired selection is displayed, press PRINT to accept the value. Continue this
procedure throughout the setup routine until all required changes have been made.
Exiting the Programming
Mode
At the end of all the program blocks, there is a SAVE program block. In this block, you
can use the FUNCTION key to select SAVE, ABORT or DEFAULT. When the desired choice
is displayed, press PRINT. The scale exits the programming mode after the selection.
SAVE The WILDCAT scale will save all the changes you have made to the program
blocks and then exit setup.
ABORT All changes will be discarded and the original programming will remain.
DEFAULT All blocks, except those steps denoted by *s in Table 3-1 are reset to the
factory defaults.
Sealing the Enclosure
(Legal for Trade)
After calibration is complete, setup step F1.4 should be programmed as a “O” to
eliminate accidental changes to the calibration values. After programming is complete,
remove the setup jumper CAL (Figure 3-2) to prevent setup access. Close the enclosure,
tightening all four screws on the rear cover. Install the two plastic plugs over the bottom
screws and seal the enclosure as shown in Figure 3-3.
Figure 3-3