User's Manual

SAFETY
Warning! Use under the direct supervision of an adult.
Never drive Spy Video Car on real streets
Keep fingers, hair, and loose clothing away from the tires while the vehicle is switched
on.
With the Video Screen flipped down, your vision is impaired. Flip the screen UP when walking or
moving. Never run while wearing the video glasses, especially in the dark.
BATTERY INFORMATION
The Spy Video Car uses 12 AA (6 for the car and 6 for the remote) batteries, not included.
ATTENTION ADULTS: TO REPLACE BATTERIES
1. Use a small Phillips head screwdriver to loosen the screws on the battery compartment of
both the car and the remote. The screws will not fall out.
2. Open battery cover. Remove exhausted batteries.
3. Place new batteries in compartment as shown in Fig. 1 and 2.
4. Replace the battery cover and tighten screw.
BATTERY SAFETY INFORMATION
Requires 12 AA batteries
Only adults should install and replace batteries.
Do not recharge non-rechargeable batteries.
Remove dead or exhausted batteries.
Insert batteries correctly. Match positive and negative signs.
The supply terminals are not to be short-circuited.
Do not use rechargeable batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
Do not mix old and new batteries.
Only the batteries of the same or equivalent type recommended to be used.
Do not dispose batteries in a fire; they may explode.
Dispose of batteries safely.
Caution: Changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
FCC ID: N3EVIDEOCAR70133T, FCC ID: N3EVIDEOCAR70133R
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.