User's Manual

ADULTS: To install or change batteries (each unit)

1. Using a Philips screwdriver, loosen the screw on the battery cover. The screw

will not fall out.

2. Remove the cover.

3. Install three fresh AAA alkaline batteries in each unit, following the diagram

engraved inside the battery box.

IMPORTANT: Make sure to install batteries in each unit AS SHOWN: two up,

one down. If your Seeker does not work, double check the battery positions.

4. Reinstall the battery cover and tighten the screw.

Battery Safety:

1. Only adults should install and replace batteries.

2. Do not recharge non-rechargeable batteries.

3. Remove dead or exhausted batteries.

4. Insert batteries correctly. Match positive and negative signs.

5. Do not place anything across the battery terminals.

6. Only use the batteries specified above.

7. Do not use rechargeable batteries

8. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)

batteries.

9. Do not mix old and new batteries.

10. Do not dispose batteries in a fire; they may explode.

11. Dispose of batteries safely

FCC legal Device operates at 915MHz

Logo Wild Planet

UPC Spy Seeker

0000-0000-0000

Consumers

If you have any questions, please contact us at 1-800-247-6570.

www.wildplanet.com

FCC NOTE:

THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED

BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS

COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.