User's Manual

FLIPPER FRENZY 46111-4000 PS 05/10
IF YOU HAVE ANY QUESTIONS, PLEASE CONTACT US AT
1-800-247-6570
WILDPLANET.COM/HELP
Wild Planet Entertainment, Inc., P.O. Box 194087
San Francisco, CA 94119-4087
© 2010 Wild Planet Entertainment, Inc.,
San Francisco, CA 94104,USA
All Rights Reserved. MADE IN CHINA.
Foreign patents pending.
Product specifications subject to change.
BATTERY SAFETY INFORMATION
• Requires 3 AAA (LR03) batteries.
• Only adults should install and replace batteries.
• Rechargeable batteries are to be removed from the
character before being charged.
• Rechargeable batteries are only to be charged under
adult supervision.
• Non-rechargeable batteries are not to be recharged.
• Remove dead or exhausted batteries.
• Insert batteries correctly. Match positive and
negative signs.
• The supply terminals are not to be short circuited.
• Do not mix different types of batteries.
• Do not mix old and new batteries.
• Only the batteries of the same or equivalent type
recommended to be used.
• Do not dispose batteries in a fire; they may explode.
• Dispose of batteries safely.
ATTENTION ADULTS: TO REPLACE BATTERIES
1. Use a small Phillips head screwdriver to loosen
the screw on the battery compartment (Fig. 1).
Remove BATTERY COVER.
2. Pull BATTERY RIBBON firmly to pop out all 3 exhausted
batteries.
FCC ID N3EFLIPPERFRENZY
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning! Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This unit has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This unit generates,
uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this unit does cause harmful interference to radio or television
reception, which can be determined by turning the unit off and on,
the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the unit and receiver.
• Connect the unit into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
3. Place battery ribbon across bottom of battery compartment as
shown (Fig. 2).
4. Place 1 fresh, new AAA battery in the bottom of the
compartment with the positive (+) end pointing down
as shown (Fig. 3). SNAP BATTERY IN FIRMLY.
5. Fold ribbon back over first battery as shown (Fig. 3).
6. Place 2 AAA batteries in the remaining 2 battery holders, on top of
ribbon, with each battery pointing in the direction shown (Fig. 4).
IMPORTANT: Observe battery polarity (+ and –)
7. Replace battery cover, making sure end of ribbon is tucked neatly
inside. Tighten screw.
Fig. 3
Fig. 4
Battery Ribbon
Fig. 2
Battery Cover
Fig. 1