Use And Care Manual

11
• Breaking or catapulting of knife pieces.
• Carbon monoxide poisoning when using the device in closed or poorly ventilated rooms.
• Burning when touching hot parts.
• Impairment of hearing when working on the machine for longer periods of time without ear protection. In
addition, in spite of all the precautionary measures taken,non-obvious residual risks can still exist. Residual
risks can be minimised if the “Safety information” and the “Intended usage” as well as the whole of The
operating instructions are observed.
5. Attachment and operation
ATTENTION! Before working on the device - cleaning, inspection, maintenance or other work -
always turn off the device.
ASSEMBLY
The blower must not be used or switched on until it has been fully assembled.
Assembly (Fig6-6c)
• Attach the two hose clamps (17A and 17B) to the flexible blowpipe (12).
• Push the flexible blowpipe (12) over the connection to the motor unit and tighten the hose clamp (17B)
firmly (Fig. 6).
• Now push the handle (1) over the upper blowpipe (13). Align the handgrip (1) and the guide in the same
way, fold it together and then tighten it (Fig. 6a).
• Push the upper blowpipe into the flexible blow hose (12) with the handle and fix it with the hose clamp
(17A) (Fig. 6b).
• Push the lower blowpipe (14) over the upper blowpipe (13) and lock it in the clockwise direction (Fig. 6c)
• The blower nozzle (No. 15) is simply pushed over the lower blowpipe (No. 14) and locked in the
clockwise direction (Fig. 6c).
Warning! Use only original manufacturer‘s replacement parts, accessories and attachments.
Failure to do so can cause poor performance, possible injury and may void your warranty. Never
use the machine without the guard assembled!
Operation
Before starting
Each time before use, check the following:
That there are no leaks in the fuel system.
That the equipment is in perfect condition and that the safety devices and cutting devices are
complete.
That all screws are securely fastened.
That all moving parts move smoothly.
Place the carrying strap
Pull the belt down, the straps are tightened
Loosen the straps
Lift the clamping slide
Adjust the carrying strap so that the back plate rests firmly and securely against.
Fuel and oil
Recommended fuels
Use only a mixture of unleaded petrol and special 2-stro-ke engine oil. Mix the fuel mixture as indicated in
the fuel mixing table. (Fuel/Oil 50:1)
Important: Do not use a fuel mixture which has been stored for longer than 30 days.
Important: Never use 2-stroke oil with a recommended mixing ratio of 100:1. The manufacturer’s
warranty will be voided in case of engine damage due to inadequate lubrication.
Important: Only use containers designed and approved for the purpose to transport and store fuel.
Pour the correct quantities of petrol and 2-stroke oil into the mixing bottle (see scale printed on the bottle).
Then shake the bottle well.