User Manual

7
TROUBLESHOOTING
SYMPTOM
POSSIBLECAUSE
SOLUTION
DifcultyprimingtheTCCtea
dispenser.
Adjusting rod on mixing valve is turned
in too far.
Openupthevalve1/4turncounter
clockwise.
Tea does not dispense from
faucet.
Water line is turned off.
Turn on water line valve.
Onlywaterowingfromfau-
cet, no tea.
1.TeaconcentrateBIBisoutofproduct.
2.TheteaBIBlineiskinked.
3.TheteaBIBlineisclogged.
4. The check valve in the tea concen-
tratelinemaybestuckclosed.
5.Theadjustmentscrewmaybeturned
in or closed.
1.ReplacetheteaconcentrateBIB.
2. Trace the tea line and straighten out
kinked hose.
3.Blowouthosetocleanblockageor
replace with a new hose.
4. Loosen the clamps and remove the
checkvalve.Cleanorreplaceit.
5.Openthemixingvalvetoresume
productow.
Faucetisdrippingconstantly. 1.Thefaucetseatcupmayhavehard-
ened particles keeping the faucet
from sealing.
2.Theremaybeatearorcutinthe
seat cup.
3.Waterpressuremaybetoohigh.
1.Disassembleandcleantheseatcup
(see cleaning section).
2. Replace the seat cup.
3.CallCURTISCAREforinstructions
on adjusting the water regulator.
Finished tea is weak. 1. The mixing valve is out of adjust-
ment.
2.Theproductcheckvalvemaybe
stuck.
1.Openthemixingvalvetoincreasetea
concentrateow.
2. Remove and clean the check valve.
Makesurecheckvalveisinstalled
withcorrectowdirection.
Productowingfromthefau-
cetistoofoamyorbubbly.
1.Theclampsatthecheckvalvemay
not be tight.
2. TheclampontheQCDconnector
maybeloose.
3. Teaconcentrateproductmayhave
airintheBIB.
4.TheO-ringontheQCDiswornout.
1. Reconnect tubing and tighten clamps.
2.Makesurethebarbedendofthe
QCDttingispushedinonthehose
and the clamp is tight.
3.TurntheBIBsothettingfacesup-
ward and open the faucet until all the
bubbles are released.
4.ReplacethewornO-ringorinstalla
newQCD.