Manual

2
SPRAYHEADS:MentionedinthisProgrammingguidearethewordsGrayandPurple.Thisreferstothecolorofthespray-
head.ThecurrentsprayheadisthepurpleAFS.Theolderversionisthegraysprayhead.Seetheillustrationatright.
PURPLE
GRAY
To Access Programming
Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button #4 and then press and release ON/OFF button (yellow).
Continue holding the #4 button. Display will read , wait until is displayed Enter the 4-digit access code, the digits 1-4 corre-
spond to the buttons (see illustration below).
The default code set at the factory is 1-2-3-4. Then will be displayed.
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
4
31 2
YourCurtisGeneration3BrewerisFactoryPre-SetforOptimumPerformance.
Afterconnectiontowaterandpower;thereartoggleswitchmustbeon.Youwillhearabeepsound,indicatingpowerisavailabletothecontroller.
Thecontroldisplays  .PressON/OFFbuttonandthescreenwilldisplay  .Afterthreeseconds, isdisplayed.
Waterwillllthetank(approximately2-3minutesdependingonwaterowrate).Whentheproperlevelisreached willappearonthe
screen.Ittakesapproximately20minutestoreachsetpointtemperatureof204°F.
Controlwilldisplay  whentemperaturereachesthesetpoint(204°F).Unitisnowreadytobrew.
CURTIS <TCT-RC>
CURTIS
CURTIS
FILLING
CURTIS
HEATING
CURTIS
READYtoBREW
1. Brewer should be ON (Conrm at rear toggle switch, then press ON/OFF button) and Ready-to-Brew displayed.
2. Make sure tea containers are in place, sitting on the brew deck.
3. Place a paper lter in
the brew basket. Pour
leaf tea into the lter.
Place the lter into the
brew cone.
4. Slide brew cone into
brew rails.
6. Press the desired brew
button on the UCM
control panel. The brew
cycle will start.
5. Select the tea container
you wish to brew into
and rotate the brew
cone to direct the ow
into that tea container.
Tea Brewing Instructions
CAUTION HOT LIQUID, Scalding may occur. Allow the brew cone to completely drain before removing.