Owner's manual

6
Error Message
Anerrormessagewillappearonthe
screen in the event of a malfunction
underthefollowingconditions:
1.Waterleveloverow.
2.Breakintemperaturecontrol
circuit.
3.Excesstemperatureinheating
tank
4. Scalebuild-uponliquidlevel
probe,insidetheheatingtank.*
Toturnoffanerrormessage,press
the ¤buttonforveseconds.
*TheScaleerrorfeatureswillbegin
appearinginlaterversionsofGEM
Intellifreshbrewers.
Warmers
Thewarmer,underthebrewconewillturnonautomaticallywheneveracoffeebrewcycleisstarted.Thewarmersmaybeswitchedonandoff
usingtheWARMERbuttonsonthecontrolpanel.
ModelSelect
Model Select (Factory set to Gemini-Twin IF)
Press ¤ to select, < or > to select model. The selections are: ThermoPro-Twin, ThermoPro-Single, Gemini-Twin, Gemini-
Single, Milano-Twin, Milano-Single, Gemini-Twin IF, and Gemini-Single IF. Press ¤ to set. When the Model Select feature is
changed, all settings are reset to the defaults of the newly selected model. Also, the next feature Batch Select appears.
Batch Select (Factory set to One Batch)
Press ¤ to select, < or > to select One Batch, Two Batch or Three Batch. Press ¤ to set. Display exits programming mode
and returns to normal operation.
Program Menus GEMIF Brewer
Language (Factory set to English)
Press ¤ to Select. Press < or > to move to English or French. This feature is programmable for changing and adding
languages.
Language
By-Pass (Factory settings: LARGE 35%. MEDIUM 10%. SMALL Off.)
The By-Pass option helps with controlling extraction with larger brews. Contact time that is too long will extract undesirable
bitter, harsh avor compounds. By-passing some of the brew water around the coffee bed will balance the extraction.
Press ¤ to display current setting. Press < or > to change settings; OFF, 5% to 50%, in 5% increments. Press ¤ to set.
By-Pass