User guide

4
Parts List
Guidelines for Pulse Brew:
Thisfeatureallowstuningofthecoffeeavor.ThepotlevelshouldalwaysbesetrstwiththisoptionOFF.Dependingonyourgrind
proleandwaterconditions,thevePulseBrewoptionshelp“tune”orchangethecoffeeavor.FilterPacktypecoffeestypically
extract better with the A and B pulse setting. Decaffeinated coffees typically extract better with the B pulse setting. High-Yield coffees
typicallyextractbetterwiththeCpulsesetting.Ofcourse,anyoftheA,BorCsettingsmaybeusedtosuityourtasteprole.Thereare
two additional settings (D and E) that allow you to manually set the ON TIME pulses and OFF TIME.
IfPulseBrewisselected(ON),ColdBrewLockissettoDelta1within5ºFofsetpoint.ColdBrewLockandPre-infusiondisappears
from the list of program selections. When Pulse Brew is ON, Pre-Infusion disappears from the list of program selections.
Display Brew Time (Factory set to ON)
Press  to display ON or OFF. Pressing either < or > toggles between on and off.  to set. When on, the Display Brew Time feature
allows you to see the remaining time in the brew cycle counting down.
Drip-Out Mode (Factory set to 2 min)
Press  to select. Press > to increase time (to a maximum of 5 minutes) or < to decrease the time and turn OFF. Time counts up in 5
second increments. Press  to set.
Display Messages (Factory set to ON)
Press  to turn ON or OFF. The message displayed is “Rinse Server Before Brewing”. This message will alternate; two seconds with
Rinse Server Before Brewing, then Curtis READY TO BREW will appear for six seconds.
Exit
Press  to select, exits program mode and returns unit to operation. Pressing >returnsyoutoBrewByVolume.
Exit
Drip-Out
Mode
Display Brew
Time
Drip-Out
Mode
BREWCONE,W/HANDLEASSY7.1”D
BREW CONE, ASSY S.S. (OPTIONAL)
COVER,TOP
VALVE,DUMPVALVELEFT120VAC10W
VALVE,DUMPLEFT220V12W
KIT,FITTINGSPRAYHEADKYNAR
VALVE,DUMPRIGHT120V12W
VALVE,DUMPRIGHT240V9W
BRACKET,UCM
KIT,UCM&OVERLAYD1000GT
CONTROLMODULE,220VD1000GT/H
LABEL, DUAL UCM PANEL
COVER,FRONTD1000GT
FAUCET, HOT WATER W/JAM NUT
SEATCUP,SILICONE(USEONWC-1809)
HEATSINK,1PHASSEMBLY
SPRAYHEAD,PURPLEADVANCEFLOW
CAPACITOR, X2
LEG,GLIDE3/8-16STUDSCREW
LEG,3/8-16STUDSCREW
TANK,COMPLETED1000GT220V
TANK,COMPLETED1000GT/H120/220VDV
VALVE,INLET2GPM
VALVE,INLET1GPM240V10W
SWITCH,TOGGLENON-LITDPST25A125/250V
KIT,VALVEREPAIRUSEONWC-889/WC-817
GRID, DRIP TRAY AIRPOT (OPTIONAL)
TUBING,SILICONE,5/16”I.D.(1FT.)
KIT,PROBEWATERLEVELW/NUT&O’RING
ELEMENT,HEATING2.5W220V
GUARD,SHOCKHEATINGELEMENT
SENSOR,TEMPERATURETANK
GUARD,SHOCKRESETTHERMOSTAT
THERMOSTAT, HI LIMIT HEATER CONTROL
COMPOUND, SILICONE 5 OZ TUBE
KIT,HEATINGTANKLID
KIT,VALVEREPAIRUSEONWC-847
Item№ Part№ Description
1
1A
2
3
3A
4
5
5A
6
7
7A
8
9
10
11
12
13
14
15
16
17
17A
18
18A
19
20
21
22
23
24
25
26
27
28
29
30
31
WC-3316-101
WC-3316
WC-5421
WC-889*
WC-860
WC-2962-101K
WC-817*
WC-861
WC-67101
WC-37177*
WC-789
WC-39396
WC-5847
WC-1809
WC-1806
WC-8560
WC-29025*
WC-8591*
WC-3518
WC-3503
WC-75285
WC-75284
WC-847*
WC-856
WC-103*
WC-3763*
WC-6221
WC-5310*
WC-5502-01*
WC-934-04*
WC-4394
WC-1438-101*
WC-43055
WC- 522
WC-5231*
WC-37008*
WC-3765L*