User Manual

2
Steps to Programming
Your Curtis Cafe PC System is factory preset for optimal performance. Usually this does not change.
Manual Liquid Dispensing Mode
ThisfeaturesetsuptheCAFEPCunittodispenseproductonlyaslongastheuserholdsdowntheselectedPUSHbutton.
Assoonastheuserstopspressingthebutton,productstopsowingintothecup.SettingtheunitforManualLiquidDispensewillturnoffthe
PortionControlDispenseMode.
Enter program mode –PressandholdtheSTOP/WASHbuttonforaboutten[10]seconds,
untilallthelightsstartblinking.
To change the product throw -Pressandholdthebuttonuntilthelightstartsquickashing.Eachquickash
increasestheamountby10%.Releasethebuttonwhenthedesiredthrowamountisachieved.Afterreleasingthe
button,thenumberofblinksrepresentthenewsetting.
To exit powder dispensing mode - Push any other PUSHbutton.
To program the product % ratio - PressandholdtheselectedPUSHbuttonforapproxi-
matelyonesecond,thenrelease.ThecurrentsettingwillbeindicatedbyLEDashes.
Product % Ratio
Thisfunctioncontrolstheamountofdryproductthatismeteredfromthehoppers.Itcanbeprogrammedfrom10%to
100%ofthecapacityofthedispensingsystem.BycountingLEDashesyoucandeterminetheproduct%ratio
currentlysetforeachdispensebutton(seetable).
Portion Control Liquid Dispensing Mode
Thisprogramadjustmentallowsyoutosetupthemachinetoautomaticallydispenseapresetvolumeofcappuccinoproduct.Whentheuser
makesaPUSHbuttonselection,theunitdispensesonlythevolumeofcappuccinoproductprogrammedbythePortionControlDispensing
Mode.WhensettingtheunitforPortionControlDispensing,youlockoutthemanualdispensefeature.
Enter program mode –PressandholdtheSTOP/WASH buttonforaboutten[10]seconds,untilalllightsstart
blinking.
Stop & exit –When3/4ofthecupvolumeisachieved,pressthePUSHbuttononceagaintostopdispensing.
Youhavenowsetthetimingforthisbuttonandhaveexitedprogrammode.Pressingthedispensebuttonnowwill
providetheliquidvolumethatyoujustset.Toresetthetiming,youmuststartagainbyenteringprogrammode.
To select and change the portion control dispensing volume – Whileintheprogrammingmode,pressandhold
theselectedPUSHbuttonuntiltheliquidbeginstoow,thenrelease.Thetimingstartswhenliquidbeginstoow.
WARNINGHOTLIQUID-Scalding
mayoccur.Avoidsplashing.
Placeanemptycontainerunderthe
dispensingnozzleswhileprogramming.
Allprogrammingisperformedatthecontrolpanel
(illustration,right).TheSTOP/WASHbuttonhas
severalfunctions.Thisbuttonisusedtostopa
portioncontroldispensecycle.Itisalsousedto
washoutthemixinganddispensingsystemsandtoenterprogrammingfunctions.