User Manual

ManualsBrandsWilbur Curtis ManualsCommercial Beverage EquipmentCafé Primo Cappuccino System 2 Station Cappuccino (4 Lb Hoppers) - Commercial Cappuccino Machine - CAFEPC2CS10000 (Each)

Symbols

WARNINGS – To help avoid personal injury

Important Notes/Cautions – from the factory

Sanitation Requirements

1. Connectawaterlinefromyourfacilitytothe1/4”arewaterinletttingofthevalve,behindthemachine.Thewatervolumegoingto

themachineshouldbestable.Usetubingsizedsufcienttoprovideaminimumowrateofonegallonperminute.

2. Plugthepowercordintoanelectricaloutletratedat20A.

3. Switchonthetoggleswitchbehindtheunitthatsuppliespowertothecomponentsinthemachine.ThedisplaywindowandSTOP/

WASHlightonthefrontdoorwillactivateandtheheatingtankwillstarttoll.

4. Waterintheheatingtankwillrequireabout½hourtoreachoperatingtemperature(factorysettingof190°F).AtthistimetheReady 

lightwillappear.

5. Removeandllthecanisterswithpowderedcappuccinomixes.

FOR THE LATEST SPECIFICATIONS AND INFORMATION GO TO WWW.WILBURCURTIS.COM

Thisapplianceisdesignedforcommercialuse.Anyservicingotherthancleaningandmaintenanceshouldbeperformedbyan

authorizedWilburCurtisservicecenter.

•DONOTimmersetheunitinwateroranyotherliquid.

•Toreducetheriskofreorelectricshock,DONOTopenthetoppanel.Therearenouserserviceablepartsinside.

•Keephandsandotheritemsawayfromhotpartsoftheunitduringoperation.

•Nevercleanwithscouringpowdersorharshimplements.

Your Curtis CAFE PC System is factory preset for optimal performance… right from the carton.

FollowingarethefactorysettingsforyourPrimoCappuccinoBeverageSystem:

 •Tanktemperature=190°F •Flavorcontrols=setat50% •Dispensingmodesetformanualdispensing

Generallytherewillneverbeareasontochangethefactoryprogramming.However,shouldyouneedtomakeslightadjustmentsto

meetyourdispensingneeds,programminginstructionsareprovidedlaterinthismanual.

SystemRequirements:

 •Watersource20–90psi(minimumowrateof1gpm)

 •Electrical:Seeattachedschematicforstandardmodelorvisitwww.wilburcurtis.comforyourmodel.

Equipmenttobeinstalledtocomplywithapplicablefederal,stateorlocalplumbing/electricalcodeshavingjurisdiction.

SETUP INSTRUCTIONS

Theunitshouldbelevel(lefttorightandfronttoback),locatedonasolidcountertop.Connectawaterlinefromthewaterltertothe

brewer.NOTE:Sometypeofwaterltrationdevicemustbeusedtomaintainatrouble-freeoperation.(Inareaswithextremelyhard

water,wesuggestthatasedimentaryandtasteandodorlterbeinstalled.)Thiswillprolongthelifeofyourdispensingsystemand

enhancecappuccinoproductquality.

NSFInternationalrequiresthefollowingwaterconnection:

1. Aquickdisconnectoradditionalcoiledtubing(atleast2xthedepthoftheunit)isrequiredsothattheunitcanbemovedfor

cleaning.

2. Thisunitmustbeinstalledwithadequateback-owprotectiontocomplywithapplicablefederal,stateandlocalcodes.

3.Waterpipeconnectionsandxturesdirectlyconnectedtoapotablewatersupplyshallbesized,installedandmaintainedin

accordancewithfederal,stateandlocalcodes.

FILL CANISTERS DAILY

1. Openthefrontdoortoaccessthecanisters.

2. Turntheproductdeliveryelbowsupward.Lifteachcanisterupslightly,thenout.

3. Afterlling,repositionthecanistersinthemachine,aligningthegearsocketwiththe

 motorshaftintheback,thenturningtheproductdeliveryelbowsdownward.

Important Safeguards & Symbols

CAUTION: DONOT

connect this unit to hot

water.Theinletvalveis

notratedforhotwater.

CAUTION: Please use

thissetupprocedure

beforeattemptingtouse

thisappliance.Failuretofollowthe

instructionscanresultininjuryorthe

voidingofthewarranty.

WARNINGHOTLIQUID,

Scaldingmayoccur.

Avoidsplashing.

Models Included

wCAFEPC1

wCAFEPC1WITHLIGHTBOX

wCAFEPC2

wCAFEPC2WITHLIGHTBOX

wCAFEPC3

wCAFEPC3ICEDCAPPUCCINO

w CAFEPC3WITHLIGHTBOX

w CAFEPC4

w CAFEPC4WITHLIGHTBOX

OPERATING INSTRUCTIONS

1. Chooseaavor.Placeacupunderthespoutbeneaththedesiredavor.

2. Pushandholdthedispensingbuttonforthedesiredavor.

3. Releasethebuttonwhenthecupis¾full.

Wilbur Curtis Co., inC.

ServiceManual–CAFEPC

ISO9001:2008REGISTERED

WILBURCURTISCO.,INC.

6913AccoStreet

Montebello,CA90640-5403

Forthelatestinformationgoto

www.wilburcurtis.com

Tel:800-421-6150

Fax:323-837-2410

Summary of content (8 pages)

PAGE 1
Wilbur Curtis Co., Inc. Service Manual – CAFEPC Important Safeguards & Symbols This appliance is designed for commercial use. Any servicing other than cleaning and maintenance should be performed by an authorized Wilbur Curtis service center. • DO NOT immerse the unit in water or any other liquid. • To reduce the risk of fire or electric shock, DO NOT open the top panel. There are no user serviceable parts inside. • Keep hands and other items away from hot parts of the unit during operation.
PAGE 2
Steps to Programming Your Curtis Cafe PC System is factory preset for optimal performance. Usually this does not change. WARNING HOT LIQUID - Scalding may occur. Avoid splashing. Place an empty container under the dispensing nozzles while programming. All programming is performed at the control panel (illustration, right). The STOP/WASH button has several functions. This button is used to stop a portion control dispense cycle.
PAGE 3
Programming Continued ... Enter program mode – Press and hold the STOP/WASH button for about ten [10] seconds, until all the lights on the control panel are blinking. Set manual dispense – While you are in programming mode, press and hold the PUSH button. Hot liquid will start to flow. Continue to hold down the PUSH button until liquid stops flowing, then release the button. At this time, you have selected the manual liquid dispensing mode and have exited out of program mode.
PAGE 4
Dump Valve Replacement Curtis recommends that you regulate the water flow in the valve ONLY when replacing a valve. WARNING - ELECTRIC SHOCK/BURN HAZARD. Be sure the power cord is disconnected before removing components. The following steps involve working near hot surfaces. I. Instructions for replacing a valve: A. Shut off the water line running to the unit. B. Disconnect the power cord and turn off the toggle switch behind the unit. C.
PAGE 5
Illustrated Parts List 3 1 2 10 53 4 8 5 6 7 55 11 31 54 12 32 13 14 33 19 20 21 22 15 16 17 34 35 36 37 38 39 40 25 26 27 28 29 30 18 23 41 42 24 43 46 44 48 25 47 D 45 9 34 VIEW SHOWN ROTATED WC-39107-02 5
PAGE 6
Illustrated Parts List Light Box Option 49 50 52 51 Illustrated Parts List Item Nº 1 1A 2 3 4 5 6 7 8 8A 8B 8C 9 10 10A 10B 11 11A 12 13 14 15 16 17 18 19 19A 19B 19C 20 20A 20B 21 21A 21B 21C 21D 21E 22 22A 22B 23 23A 23B 24 24A 24B 24C Part Nº WC-5853-102 WC-5851 WC-430621 WC-5527K1 WC-37341 WC-904-041 WC-1438-1011 WC-5211 WC-62019 WC-62020 WC-6291 WC-62021 WC-3765L1, 2 WC-58137 WC-7389 WC-58151 CA-1111-06 CA-1124-06R CA-1026-03 CA-1095 CA-1011-05 CA-1005-031 CA-1009-031 CA-1135 CA-1006-061 WC-58185
PAGE 7
Electrical Diagram NEWER UNITS EQUIPPED WITH 9W LED LIGHT.
PAGE 8
Product Warranty Information Wilbur Curtis Co., Inc. certifies that its products are free from defects in material and workmanship under normal use. The following limited warranties and conditions apply: 3 years, parts and labor, from original date of purchase on digital control boards. 2 years, parts, from original date of purchase on all other electrical components, fittings and tubing. 1 year, labor, from original date of purchase on all electrical components, fittings and tubing.