User Manual

2
Steps to Programming
Your Curtis Cafe System is Factory Pre-Set for Optimum Performance. Usually this Does Not Change.
Manual Liquid Dispensing Mode
ThisfeaturesetsuptheCaféPCunittodispenseproductonlyaslongastheuserholdsdowntheselectedPUSHbutton.
Assoonastheuserstopspressingthebutton,productstopsowingintothecup.SettingtheunitforManualLiquidDispensewillturnoffthe
PortionControlDispenseMode.
Enter Program Mode –pressandholdSTOP/WASHforaboutten[10]secondsuntilall
lightsstartblinking.
To program Product % Ratio,pressandholdtheselectedPUSHbuttonforapproximately
onesecond,thenrelease.ThecurrentsettingwillbeindicatedbyLEDashes.
To change the product throw,pressandholdthebuttonuntillightstartsquickashing.Eachquickashincreases
theamountby10%.Releasethebuttonwhenthedesiredthrowamountisachieved.Afterreleasingthebutton,the
numberofblinksrepresentthenewsetting.
To exit the Powder Dispensing Mode,pushanyotherPUSHbutton.
Product % Ratio
Thiscontrolstheamountofdryproductthatismeteredfromthehoppers.Thiscanbeprogrammedfrom10%to100%
ofthecapacityofthedispensingsystem.BycountingLEDashesyoucandeterminetheproduct%ratiocurrentlyset
forthisdispensebutton(seetable).
Portion Control Liquid Dispensing Mode
Thisprogramadjustmentallowsyoutosetupthemachinetoautomaticallydispenseapresetvolumeofcappucinoproduct.Whentheuser
makesaPUSHbuttonselection,theunitdispensesonlythevolumeofcappucinoproductprogrammedbythePortionControlDispensing
Mode.BysettingtheunitforPortionControlDispensing,youhavelockedoutthemanualdispensefeature.
Enter Program Mode –pressandholdSTOP/WASH foraboutten[10]secondsuntilalllightsstartblinking.
To select & change the Portion Control Dispensing Volume – whileintheprogrammingmode,pressandholdthe
selectedPUSHbuttonuntiltheliquidbeginstoow,thenrelease.Thetimingstartswhenliquidbeginstoow.
Stop & Exit –When3/4ofthecupvolumeisachieved,pressthePUSHbuttononceagaintostopthedispensing.
Youhavenowsetthetimingforthisbuttonandhaveexitedtheprogrammingmode.Pressingthedispensebutton
nowwillprovidetheliquidvolumethatyoujustset.Toresetthetiming,youmuststartagainbyenteringtheprogram-
mingmode.
WARNINGHOTLIQUID,Scalding
mayoccur.Avoidsplashing.
Placeanemptycontainerunderthe
dispensingnozzleswhileprogramming.
Allprogrammingisperformedatthecontrolpanel
(illustration,right).
TheSTOP/WASH BUTTONhasseveralfunc-
tions.ThisbuttonisusedtostopaPortionControl
dispensecycle.Itisusedtowashoutthemixinganddispensingsystemsanditisusedtoenterprogrammingfunctions.