Service manual

Your Curtis ADS System is Factory Pre-Set for Optimum Performance.

After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.

The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.

Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the screen.

It takes approximately 20 minutes to reach setpoint temperature of 200°F.

Control will display when temperature reaches the setpoint (200°F). Unit is now ready to brew.

THERMO-PRO

WILBUR CURTIS

FILLING . . .

WILBUR CURTIS

HEATING . . .

WILBUR CURTIS

READY TO BREW

All programming selections are performed with the three center buttons.

The symbols below the buttons are:

Scroll LEFT

~ SELECTION or ENTER to save new parameter

Scroll RIGHT

IMPORTANT NOTE:

ThermoPro