Service manual

YourCurtisADSSystemisFactoryPre-SetforOptimumPerformance.
Afterconnectiontowaterandpower;thereartoggleswitchmustbeon.Youwillhearabeepsound,indicatingpowerisavailabletothecontroller.
Thecontroldisplays  .PressON/OFFbuttonandthescreenwilldisplay  .Afterthreeseconds, isdisplayed.
Waterwillllthetank(approximately2-3minutesdependingonwaterowrate).Whentheproperlevelisreached willappearonthescreen.
Ittakesapproximately20minutestoreachsetpointtemperatureof200°F.
Controlwilldisplay  whentemperaturereachesthesetpoint(200°F).Unitisnowreadytobrew.
GEM TN
PROGRAM MENUS
All programming selections are performed with the three center buttons.
The symbols below the buttons are:
Scroll LEFT
 SELECTION or ENTER to save new parameter
Scroll RIGHT
IMPORTANT NOTE:
2