Service manual
2
Your Curtis Generation 3 Brewer is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound,
indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display
. After three seconds, is displayed.
Water will ll the tank (approximately 2-3 minutes depending on water ow rate). When the proper level
is reached will appear on the screen.
It takes approximately 20 minutes to reach set point temperature of 204°F.
Control will display when temperature reaches the set point (204°F). Unit is now ready
to brew.
Getting Started
WARNING TO AVOID SCALDING, Do not remove the brew cone or coffee container until the
UCM screen indicates that the brew cycle has nished.
1. Brewer should be ON (Conrm at rear toggle switch, then press ON/OFF button). Ready-to-Brew
should be displayed on the screen.
2. Make sure tea container is correctly placed on the brew deck, centered under the brew cone.
3. Place a new lter into the
brew basket. Pour leaf tea
into the brew cone.
4. Slide the tilled brew cone
into brew rails.
6. Select the desired BREW
button and press to start
brewing tea.
Tea Brewing Instructions