Miro User Manual
33
Norsk
Recommended Dimensions
The fuel’s dimensions are important for good combustion, and should be as follows:
Fuel type Length in cm Diameter in cm
Kindling (nely split rewood) 14-28 2-5
Split rewood 14-28 7-9
Using the Air Damper
To achieve good combustion, which results in better heating efciency, it is important to add
the right amount of air to the re. Air is regulated with a user-friendly, one-lever system that is
located under the stove door; see Figure D.
When lighting a cold stove and when fuellingwith new wood, the regulating lever must be pu-
shed to the extreme left to give the re maximum air supply. When the re is burning well, the
air supply can be gradually reduced by moving the regulating lever to the right.
The re will die out if the regulating lever is moved to the extreme right. This setting should
only be used in the case of overheating, if there is a re in the chimney and when the re in the
stove has been allowed to go out completely in connection with cleaning, for instance.
Some Things Worth Knowing about Firing
Maximum Firing Amount
Maximum amounts per hour:
Fuel Maximum amount per hour
Wood 2.5 kg
Warning: Too much heat can destroy your wood-burning stove, the chimney and your re-
place ducts. Therefore, if you exceed the abovementioned limits, your wood-burning stove,
chimney and replace duct will no longer be covered by the factory guarantee.
Normal Firing Interval for Nominal Firing
Fuel kg Normal ring interval
Wood 1.2 45 min
Please note: The stove is approved for intermittent use.
The Difference between Short and Long Combustion Times
Short combustion time
You create powerful warmth quickly by burning many smaller pieces of rewood.
Long Burning Time
You will obtain the longest burning time if you reduce the air supply to an absolute minimum
when the ames are dying, as this will prolong the ember phase. When you add new rewood,
set the air supply at about 40% to allow the wood to catch re.