Manual

6 Commissioning, operation
WIKA Operating Instruction, Model Pascal ET and Pascal ET/IS 37
GB
By selecting I/O the procedure requires to select the type and the range of the sensor to be used.
The sensor is identified by the measurement range and the measurement mode (g = gauge
pressure or a = absolute pressure). This information is displayed under the writing PE-1 (first
external sensor) or PE-2 (second external sensor). See the the figure below as example:
Figure 26 – Pressure sensor selection
When the sensor has been selected, the next page helps to set the engineering unit and related
number of decimals.
Figure 27 – Pressure sensor parameters selection
The pressure engineering units available are:
Measure unit
bar
mbar
ftH
2
O@4°C
inH
2
O@4°C
inHg@0°C
psf
psi
atm
torr
mH
2
O@4°C
cmH
2
O@4°C
mmH
2
O@4°C
mHg@0°C
cmHg@0°C
mmHg@0°C
kg/m
2
@g_std
kg/cm
2
@g_std
MPa
kPa
hPa
Pa