Manual

6 Commissioning, operation

34 WIKA Operating Instruction, Pascal ET and Pascal ET/IS

Once RTD USER is selected, it is possible to set the parameter of the RTD used.

A = X * 10

-3

°C

-1

B = X * 10

ˉ7

°C

-2

C = X * 10

-12

°C

-3

Ro = Resistance @ t = 0,01 °C

X = Value

Next step is to define the measurement range. The range selection is necessary during the

calibration procedure to define the relationship between the REF and DUT channels.

Figure 20 – Range setup

Now it is possible to conclude the procedure by pressing the YES button or come back to the

previous step pressing NO.

Figure 21 – Channel setup confirmation

Once the YES key is pressed, the calibrator returns to the initial page where the user can proceed

with the measurement/simulation, or assign another function to a different software channel

following the same procedure.