Instruction Manual

6 Commissioning, operation

38 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS

The instrument requires the channel role:

Figure 28 – Channel role selection

NONE to use the channel for simple measurement

REF to use the channel as reference in a comparison calibration

DUT to use the channel as measurement of a Device Under Test in a comparison

calibration

Press one of the above button (NONE, REF, DUT) to define the channel role.

Pressing REF or DUT the procedure continues as shown below:

I/O to assign a particular I/O module to the software channel.

KEYBOARD to setup by keyboard a particular value read from an external instrument

(i.e. analogue gauge).

Figure 29 – Channel mode selection