Instruction Manual

6 Commissioning, operation

32 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS

Automatically the program shows the following screen and remains in this position till the operator

select what type of parameter to associate to Channel 1.

Figure 16 – Parameter selection

The possible choices are:

■ V (Voltage)

■ mA (Current)

■  (Resistance)

■ Hz (Frequency)

■ Sw (Switch (Open/Closed))

■ T (Temperature)

■ P (Pressure)

■ HART (Hart communication) [Only when the module is fitted]

■ PULSE (Pulse)

■ NONE (No selection)

Previous set-up

A small black square in the top right side of the selection of the

Figure 16 – Parameter selection, NONE, shows the last configuration of the selected

channel. To maintain the same setting press NEXT.