User Manual

Operating Instructions Temperature Indicating Controller CF2S
V1.2
•
08/2004 - 46 -
14. Character table
<Main setting mode>
Character Item Initial value Data
Main setting 0°C
<Sub setting mode>
Character Item Initial value Data
Setting value memory number 1
Auto-tuning Perform/Cancel - - - -: Cancel
Proportional band 2.5%
Integral time setting 200s
Derivative time setting 50s
Proportional cycle R/M: 30s
S/M: 3s
Manual reset setting 0.0°C
Alarm 1 setting 0°C
Alarm 2 setting 0°C
Loop break alarm time setting 0 minutes
Loop break alarm span setting 0°C
<Auxiliary function setting mode 1>
Character Item Initial value Data
Setting value lock designation - - - -: Unlock
Main setting value high limit 400°C
Main setting value low limit 0°C
Sensor correction setting 0.0°C
Instrument number setting 0
Transfer rate selection 9600bps
Communication protocol
selection
: WIKA
standard protocol
<Auxiliary function setting mode 2>
Character Item Initial value Data
Scaling high limit setting 1370°C
Scaling low limit setting -200°C
PV filter time constant 0.0 seconds
Main output high limit setting 100%
Main output low limit setting 0%
Main output ON/OFF action
hysteresis
1.0°C
Alarm 1 action Energized/Deenergized
: Energized
Alarm 2 action Energized/Deenergized
: Energized
Alarm 1 hysteresis setting 1.0°C
Alarm 2 hysteresis setting 1.0°C
Alarm 1 delayed timer setting 0 seconds
Alarm 2 delayed timer setting 0 seconds
Display selection when control
output is off
Main setting value rising rate 0°C/minute
Main setting value falling rate 0°C/minute