User Manual

Operating Instructions Temperature Indicating Controller CF2S
V1.2
•
08/2004 - 12 -
: Options
+ : Press the key while the key is being pressed.
+ 3s: Press the key for approx. 3 seconds while the key is being pressed.
+ + 3s: Press the key for approx. 3 seconds
while the
and keys are being pressed.
+ 3s : Pressing the key, press the key for approx. 3 seconds.
*1: Step rest time is indicated only during program control.
*2: If the Auto-tuning is performed, the mode reverts to the PV/SV display.
If the Auto-tuning is released, the mode will move to “Proportional band setting”.
*3: In the mode Program control change, if is selected and the key is
pressed, the display reverts to the PV/SV display mode.
Set the temperature setting of program in the Sub setting mode, Auxiliary fuction
setting mode 1 and 2.
+ + 3s + 3s
[Auxiliary function setting mode 2] [Program mode]
Scaling high limit Alarm 1 (A1) hysteresis Program control change
setting setting
PV PV PV
*3
Scaling low limit Alarm 2 (A2) hysteresis Step 1 time setting
setting setting
PV PV PV
PV filter time constant Alarm 1 (A1) action Step 2 time setting
setting delayed timer setting
PV PV PV
Main output high limit Alarm 2 (A2) action Step 3 time setting
setting delayed timer setting
PV PV PV
Main output low limit Display selection when Step 4 time setting
setting control output off
PV PV PV
Main output ON/OFF Main setting value Step 5 time setting
action hysteresis setting rising rate setting
PV PV PV
Alarm 1 (A1) action Main setting value Step 6 time setting
Energized/Deenergized falling rate setting
PV PV PV
Alarm 2 (A2) action Step 7 time setting
Energized/Deenergized
PV PV