User Manual

Operating Instructions Temperature Indicating Controller CF1H

V 1.2

•

01/2007 - 14 -

: Options

+ MODE : Press the MODE key while the key is being pressed.

+ MODE 3s: Press the MODE key for approx. 3 seconds while the key is being pressed.

+ + MODE 3s: Press the MODE key for approx. 3 seconds while the and keys are being

pressed.

+ 3s : Pressing the key, press the key for approx. 3 seconds.

*1: Step rest time is indicated only during program control.

*2: If the Auto-tuning is performed, the mode reverts to the PV/SV display.

If the Auto-tuning is released, the mode will move to “Proportional band setting”.

*3: In the mode Program control change, if

is selected and the MODE key is

pressed, the display reverts to the PV/SV display mode.

+ MODE 3s + + MODE 3s

[Auxiliary function [Auxiliary function

setting mode 1] setting mode 2]

Setting value lock Scaling high limit Cooling output high limit

designation setting setting

MODE

Main setting value Scaling low limit Cooling output low limit

high limit setting setting setting

MODE

Main setting value Decimal point place Cooling output ON/OFF

low limit setting selection action hysteresis setting

MODE

Sensor correcting PV filter time constant Alarm 1 (A1) action

value setting setting Energized/Deenergized

MODE

Overlap/Dead band Main output high limit Alarm 2 (A2) action

setting setting Energized/Deenergized

MODE

Remote/Local changing Main output low limit Alarm 1 (A1) action

setting hysteresis selection

MODE

Instrument number Main output ON/OFF Alarm 2 (A2) action

setting action hysteresis setting hysteresis setting

MODE

Transfer rate selection Cooling action mode

selection

MODE

Communication protocol

selection

MODE