Installation Guide

Step 4
Step 6
Step 5
WH05+S6A说明书
1 2
Step 1
Step 2
INSTALLATION GUIDE
- 2 - - 3 - - 4 -
- 8 - - 9 -
- 5 -
- 6 -
Step 3
Wireless Car Charger
With Suction Cup
WH05-S6A
YOUR BEST DRIVE PARTNER
Step1: Lift carefully the dashboard pad.
Step2: Use a thin plastic card to slowly separate the adhesive
from the dashboard.
Remove Dashboard Disk Pad
Tips 3
Tips 4
Re-Usable Suction Cup
- 7 -
Tips 5
Applicable instructions
Option 1：For iPhone 12/13 Series
Option 3：For Non-Official Phone Case
Option 2：For Official Magsafe Case
Not Compatible
Windshield Dashboard
Step 6
Step 6
Dear Customer
please do not hesitate to
contact us at anytime
If you have any question
we are always here if you need!
Stick the metal ring on the center of back of the phone case
For iPhone 12/13 series without case, please DO NOT stick
metal ring to phone directly
Restore stickiness with warm water and let it air dry to use
1 2
- 5 -
Tips 2
Dashboard Pad Compatibility
For NOT SMOOTH surface, please must use the
3M dashboard pad
Tips 1
Suction Cup Removal Instructions
1
2
ATTENTION
Not compatible with leather or vinyle dashboard
FCC Warning Statement
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment. This equipment has
been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one
or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Statement
To maintain compliance with FCC's RF Exposure guidelines,
This equipment should be installed and operated with
minimum distance of 20cm the radiator your body. This
device and its antenna(s) must not be co-located or
operation in conjunction with any other antenna or
transmitter