User's Manual

WIFIX NEX5GO ROUTER – USER MANUAL
WiFiX NEXR5GO User Manual Page | 5
10. The above steps are for a general setup of the WiFi. The WiFi Mode, Channels, Width and Power may be
manually configured from its default settings. This includes the ability to lock the WiFi to a specifically channel
or, by using the Auto channel selection option.
11. To lock the WiFi to a specific Channel, Go to NETWORK > WIRELESS > DEVICE CONFIGURATION > GENERAL
SETUP, and select the preferred Channel from the drop-down list. Then, SAVE & APPLY.
12. Repeat Steps 8 through 11 to EDIT the other WiFi Interface as shown in Step 7.
13. After all of the settings are configured, we recommend rebooting the router. Allow the router a few minutes to
boot up, stabilize and apply its new configurations.
14. One of the router’s features is the ability to Reset the Firmware to its default settings. This is useful if some of
the changes adversely affected the router’s functionality or performance. This reset returns the firmware to its
original (default) configuration and removes the password, WiFi and others settings.
15. Go to SYSTEM > BACKUP / FLASH FIRMARE > RESTORE < RESET TO DEFAULTS and click PERFORM RESET: