User's Manual

─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ ─ SC-T8000 Fast Installation Guide
follow step 3 to install the next sensor
installation, after finishing press Key4 (Exit).
* a t t e n t ion : Finished inst alling, LED
shows “ red “ , I f you set different sensor
I D in the sam e place, the LED will
disappear, at t his m om ent you m ust
reset t he sensor.
〔Signal〕
1. Normal:
When tires operate in normal condition, LED
shows “green” light. Every 8 sec., the “orange”
light takes turn to show each tire’ s condition.
2. Abnormal:
When tire is in over-heated, over-pressured, or
under-pressured condition, LED shows “red”
light, locks on the position of over-heated tire
with “beep” sound.
＊
NOTE：Two tires are abnormal at the same time,
it will be fixed on the abnormal status.
3. Receiver did not receive Data:
If receiver can not receive updated tire messages
over 10 mins., LED shows abnormal indication.
Example:
Left-front tire didn’t receive data, shows “ t l ----”.
Right-front tire didn’t receive data, shows “ t2 ----”.
Left-rear tire didn’t receive data, shows “ t3 ----”.
Right-rear tire didn’t receive data, shows “ t4 ----”.
* a t t e n t io n : The abnorm al signal will be
disappear aft er once m essages received.
I f long t im e no new inform at ion, please
check your sensor.
〔FCC Notice〕
The changes or modifications not expressly
approved by the party responsible for
compliance could void the user’ s authority to
operate the equipment.
THIS DEVICE COMPLIES WITH PART
15 OF THE FCCRULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO
CONDITIONS:
(1) THIS DEVICE MAY NOT CAUSE
HARMFUL INTERFERENCE
(2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
Caution: Any changes or modifications in
construction of this device which are not
expressly approved by the party responsible
for compliance could void the user
’
s
authority to operate the equipment.