Brochure
42
RST 20i2
96.021.0053.0
96.021.0053.1
96.021.0153.0
96.021.0153.1
96.021.0453.0
96.021.0453.1
96.021.0051.4
96.021.0951.4
96.021.0050.8
96.021.0950.8
96.022.0053.0
96.022.0053.1
96.022.0153.0
96.022.0153.1
96.022.0453.0
96.022.0453.1
96.022.0051.4
96.022.0951.4
96.022.0050.8
96.022.0950.8
96.021.4053.0
96.021.4053.1
96.021.4153.0
96.021.4153.1
96.021.4453.0
96.021.4453.1
96.021.4051.4
96.021.4951.4
96.021.4050.8
96.021.4950.8
96.022.4053.0
96.022.4053.1
96.022.4153.0
96.022.4153.1
96.022.4453.0
96.022.4453.1
96.022.4051.4
96.022.4951.4
96.022.4050.8
96.022.4950.8
L, N
N, L
1, 2
2, 1
+, –
–, +
Protection
class II
6 – 10
gray
black
10 – 14
gray
black
Illumination cable
13.3 x5.3
gray
H05RNH2-F2 x 1.5
2
black
50 V
6 – 10 brown
AS-i profile cable brown
AS-i
Round cable 6 – 10
pebble gray
AS-i profile cable
pebble gray
Protection
class II
6 – 10
gray
black
10 – 14
gray
black
Illumination cable
13.3 x5.3
gray
H05RNH2-F2 x 1.5
2
black
50 V
6 – 10 brown
AS-i profile cable brown
AS-i
Round cable 6 –10
pebble gray
AS-i profile cable
pebble gray
Connector
Female conne ctor
Male connector
Application Coding Cable diameter in mm Color
Application Coding Cable diameter in mm Color
with spring clamp conn ection
Wire mm
2
Ferrules
rigid 0.5 – 2.5
fine-stranded 0.5 – 1.5 with ferrules
stranded 0.75 – 1.5 with ferrules
with spring clamp conn ection
Wire mm
2
Ferrules
rigid 0.5 – 2.5
fine-stranded 0.5 – 1.5 with ferrules
stranded 0.75 – 1.5 with ferrules
with screw connection
1)
Wire mm
2
rigid
0.75 – 6.0
2)
fine-stranded without ferrules
stranded without ferrules
with screw connection
1)
Wire mm
2
rigid
0.75 – 6.0
2)
fine-stranded without ferrules
stranded without ferrules
Unmounted with cable gland.
See the Technical Data for insulation strip
lengths as well as the ferrules to be used.
Unmounted with cable gland and locking
device.
See the Technical Data for insulation strip
lengths as well as the ferrules to be used.
Part No.
Part No.
Part No.
Part No.
1)
With wire protection available on request
2)
With 6.0 mm
2
wires, the pull and bending forces at
the connector must be taken into consideration and
compensated using suitable measures if required.