Brochure

3737
➂
➃
➃
➀
Components
3D system description
Overview of the electrical installation gesis
Basically two variations are available:
the M 25 standard device connector as
well as a modular version with M 16 or
M 20 connection threads. An angled
design completes the system.
➃ Cable assemblies
Electrical power is supplied by using
cable assemblies. Three basic versions
are distinguished: power connection
cables provide the incoming supply
of the
gesis IP+ system. They have been
prepared for a traditional connection or
with a standard plug on the supply side
and are pre-assembled with the
required female connector on the
outgoing side. Extension cables are
pre-assembled with a female or male
connector on the relevant cable ends,
and serve as feed-through wiring. The
connection cable is pre-assembled with
a male connector and a free end for
wiring to the consumer device.
➄ Distribution blocks
The pre-assembled plug-in
distribution blocks are incorporated in
the installation and thus enable a
tap-off to the consumer devices. The
distribution block is available with or
without mounting flanges.
➅ End caps
They are used to safely cover unused
contacts. The IP protection is therefore
maintained when the device is
unplugged.